From £22.79 + VAT per 20kg bag

Multipor FIX X730 lightweight adhesive mortar/plaster

Multipor FIX X730 is:-

  • a lightweight, vapour permeable adhesive for the Multipor ExSal Therm below ground insulation system.
  • used as a plaster layer, along with fibreglass mesh, over the Multipor ExSal Therm boards.
  • suitable for use as a levelling coat plaster for salt contaminated masonry.
  • suitable for below ground use inside tanking membranes.

Product overview

Where is it used?

  • Multipor FIX X730 is applied to the back of the Multipor boards to bond them to the wall surface.
  • It is used internally to level salt contaminated or damp masonry.
  • As a plaster coat, it is used internally and reinforced with a fibreglass mesh, such as Baumit StarTex mesh.

How is it used?

  • Brush and/or wash down masonry surface to remove loose material, dust and any salt contamination.
  • Once the surface has dried, apply a splatter coat of Baumit SV61 Sanova Pre to create a key.
  • If the wall surface is uneven, apply a coat of Multipor Fix X730 to level it.
  • The back of the boards should be fully coated with the FIX X730 and combed with a 10-12mm knotched trowel, to ensure an even thickness. All ridges must be full to get an even thickness coat.
  • The boards are then applied to the wall around 5mm away from adjacent boards.
  • Once in position, slide the board 5mm up to the adjacent board in a direction perpendicular to the direction of combing. This ensures that you create a fully filled layer behind the boards, with no voids present.
  • As a plaster layer, apply to the surface of the Multipor boards and comb with a 10-12mm knotched trowel to ensure an even thickness.
  • Whilst wet, lay in a layer of the Baumit StarTex mesh and trowel so that the mesh is covered by around 1mm of the FIX X730 plaster.
  • Leave to dry for 4-5 days before applying the Baumit RK 70N lime plaster finish coat or Baumit Klima Glatte lime finish coat for a finer finish.

How much will you need?

  • Each 20kg bag will cover up to 5.5m2 at 5mm.
  • You will need to use a 5mm coat as the adhesive layer and also as the base coat plaster layer.

Frequently asked questions

How long does it take to dry?

  • Allow 1mm per day for drying in warm, dry conditions.
  • In cold conditions or high humidity, drying times will be increased.

How long does it take to set?

  • You need to use mixed product in 1.5 hours or less.
  • Setting times vary with temperature and humidity but as a guide, 12 hours or so during summer months and over 24 hours in cold, damp winter conditions.

Pricing & shipping

Bag weight (kg) Coverage [m²]Single bag costFull pallet bag cost (48 bags per pallet)
20up to 5.5m2 at 5mm thickness£25.33£22.79

Book your free project consultation

We’d like to hear from you. Call us on 01392 861763 or email us at with any questions or comments.

If you can’t seem to find what you need on our website or you have large quantities of materials to purchase please contact us for a chat and we’ll offer you a more bespoke solution.

We’re normally open from 8.30 am to 5 pm Monday to Thursday, and 8.30 am to 1pm on Friday.